Advertisement
OPERATING INSTRUCTIONS
LIFTING MOWING UNIT INTO POSITION WHEN
USING THE OPTIONAL PULL GANG MOUNTING
BRACKETS
Position the mowing unit as described on the previous
page using the roller supports. See FIG. 34.
Slowly raise the mowing unit. When the hub of the
reel has been raised above the top of the V-bracket,
slowly position the left side of the reel into the bracket
and lower until you make contact with the bracket.
Now reposition the right V-bracket if necessary and
lower the reel completely into both brackets. Secure
the right bracket using both locking knobs.
FIG. 34
NOTE: On reels that have a square or hexagon shaped
hub make sure that the surface of the hub is against
the flat machined surface of the V-bracket.
CLAMP HANDLE
When the reel is correctly positioned in the V-bracket,
swing the clamping handles into place and firmly lock
in place. See FIG. 35.
NOTE: The clamping handles have two mounting
positions for large and small hubs.
NOTE: Unless the elevator hooks interfere with the
reels ability to spin, leave the elevator hooks and
spreader connected to the reel with slight tension on
the wire cable.
FIG. 35
24
Advertisement
