Advertisement
ADJUSTING FLOOR BOLTS
After the machine is positioned, adjust the bolts in
the front leg tubes.
Toward the front of each leg tube there is a bolt.
This bolt is used to remove any rocking or tipping
of the machine caused by an uneven floor. See
FIG. 7 Screw the bolt down until it just touches
the floor. Jam the nut up to lock the screw in
place. Repeat process for the other sides of the
machine. Check the machine for any instability
and make any adjustments if necessary.
SET UP GAUGE ASSEMBLY
1.Remove the dial indicator assembly from carton.
2.Remove anvil on dial indicator.
Mount dial into the casting. Remount anvil. Adjust
dial indicator so anvil can be fully depressed without
touching the casting and tighten set screw in casting to
firmly mount dial indicator to casting.
DO NOT OVERTIGHTEN OR
DAMAGE OR MALFUNCTION
OF THE DIAL INDICATOR CAN
OCCUR.
INSTALLATION INSTRUCTIONS
ADJUSTABLE BOLTS
LOCATION
ADJUSTABLE
BOLT
JAM NUT
FIXED NUT -
WELDED TO
FRAME
11
FIG. 7
SET SCREW
DIAL INDICATOR
BODY FLUSH
WITH CASTING
FIG. 8
Advertisement
