Advertisement
GETTING TO KNOW YOUR GRINDER
CONTROL PANEL COMPONENT IDENTIFICATION
Review the following control panel component
descriptions before proceeding with the instructions
FIG. 11
SYSTEM START PUSHBUTTON
The green pushbutton is the system start switch. Pushing
it will engage the magnetic starter and power the control
panel. The magnetic starter will not engage unless the
emergency stop pushbutton is pulled out and the grinding
motor switch and spin motor switch are turned off.
GRIND SELECTOR SWITCH
Variable speed spin Switch must be up to perform spin
grinding operations.
Variable Torque Relief Switch must be down to perform
relief grinding operations.
SPIN DRIVE ROTATION SWITCH
Forward / Off / Reverse
This switch reverses the direction of the spin drive motor.
IMPORTANT: Because the spin drive motor can be flipped,
the direction may be opposite of what is shown on the
decal.
SPIN SPEED POTENTIOMETER DIAL RPM
Adjusts the speed of reel rotation when you have the grind
selector switch set at variable speed spin.
14
Advertisement
