Do you have a question about the Wilo-VR-System and is the answer not in the manual?
Questions and answers
Darren
February 15, 2025
Gets up 1.3 bar cuts out
1 comments:
Mr. Anderson
February 15, 2025
The Wilo-VR-System cuts out at 1.3 bar because an overpressure threshold is set to protect the building installation. If the system pressure rises above this threshold for three seconds, the pumps in operation are switched off immediately, and the collective fault signal and overpressure LED are activated. The system restarts one second after the pressure falls below the threshold.
Need help?
Do you have a question about the Wilo-VR-System and is the answer not in the manual?
Questions and answers
Gets up 1.3 bar cuts out
The Wilo-VR-System cuts out at 1.3 bar because an overpressure threshold is set to protect the building installation. If the system pressure rises above this threshold for three seconds, the pumps in operation are switched off immediately, and the collective fault signal and overpressure LED are activated. The system restarts one second after the pressure falls below the threshold.
This answer is automatically generated