Houghton BELAIRE H2000 Owner's Manual page 18

2. Plenum operation
Press the touch screen "

modes for every pushing. The setting temperature is 24℃ in high fan FAN.

Mode display of the plenum are as: COOL "

In case the plenum touch screen key are locked by the remote controller, operations of the key would
be not available. Press the lock key on the remote controller again to unlock!
The remote controller should be operated by directing at the plenum, which will beep once

when received signal, otherwise operate after adjusting the distance and angle.
The unit will blow cold air in COOL mode and hot air in HEAT mode.

When the unit is on, press the "DISPLAY" key on the remote controller, the control plenum

LED display will be on and off.
When the unit is on, press the "LOCK" key on the remote controller to shield and

invalidate the touch screen key on the plenum.
The air-conditioner features power cut memory and automatic starting-up after power back

functions.
Low temperature heating will cause frosting, during when it is normal to show "DF" on the

plenum.
When the environmental temperature is lower than 0℃, the heating effect is reduced,

suggest to adopt other ways for heating in the same time.
If the device is left unused for long time, please remove the batteries from the remote

controller.
" key on the plenum, the setting will be circularly from "
" , DRY , FAN"
Note
"，HEAT"
Tips
15
OFF ->COOL ->FAN ->HEAT
", AUTO" " .
"