Fixing Metal - Houghton BELAIRE H2000 Owner's Manual

Connect the power supply
 Pay attention to the local wiring regulations that need
to be followed when connecting to mains supply.
 Look upward from inside the caravan, and locate the
terminal block as shown in the figure below.
 Connect the external power lines to the 3-pole terminal
block and note the positions of the active, neutral and
ground.
Match the corresponding active (brown), neutral
(blue) and the ground wire (yellow green) and
firmly tighten up the screws to make sure the
power line is not loose or improperly connected,
otherwise a short circuit or fire could be caused.
Installation of M8 bolts
 Connect M8 bolts, washers and fixing metal plates in
order as the following figure.
 Lift the plenum mounting bracket toward the machine.
 Insert M8 blots, washers and fixing plates to the holes
of the 4 corners. Start the bolts off using finger effort.
 Ensure all bolts have started correctly for at least 2 or 3
rotations to avoid cross threading.
 Ensure the metal fixing plates align with the
corresponding recess in the plenum mounting bracket
as the bolts are tightened.
 Evenly tighten up all four bolts .
Tighten the bolts to 12-14Nm torque.Do not
exceed 14Nm.
Note
3 Pole terminal block
Note
Connection of outlet air duct
 Grasp the free end of the flexible air duct and pull it
downwards towards the top of the mounting bracket.
 Pull the air duct down until it engages with the plenum
mounting bracket. The duct connects to the bracket
with four catches that will clicks when secure.
7