Operation; Fitting The Liner; Assembling The Swan Neck - ESAB MXL 200 Instruction Manual

5 OPERATION

5 OPERATION
General safety regulations for handling the equipment can be found in the "SAFETY"
chapter of this manual. Read it through before you start using the equipment!
CAUTION!
This product is intended for industrial use. In a domestic environment this product
may cause radio interference. It is the user's responsibility to take adequate
precautions.
MXL welding torches can be used in any welding position.
The torch switch in the MXL handle is suitable for 42 V, maximum 1 A.
5.1

Fitting the liner

Fit the correct wire guide liner for the application, as needed to suit the wire type and
diameter. See chapter "MAINTENANCE" section "Spiral liner / PTFE liner".
NOTE!
For information on how to install new liners and about correct assembly
procedure, see the chapter entitled "Maintenance"
Spiral liner = for steel wires
PTFE−liner = for aluminium, copper, nickel and stainless steel wires
5.2

Assembling the swan neck

The following figures indicate how to assemble the different welding torch types.
1. Gas nozzle
2. Contact tip
3. Nozzle spring
0459 560 101
4. Tip adaptor
5. Gas diffusor
- 10 - © ESAB AB 2017