Keysight Technologies 34921A User Manual page 15

CONFigure:VOLTage:DC 10,0.003,(@1003,1008)
ROUTe:SCAN (@1003,1008)
INITiate
FETCh?
Example: Making current measurements
channel 43 for a 34921A modules in slot 7 for dc current measurements, triggers
the internal DMM to scan the channel, and then sends the reading to the output
buffer of the 34980A. The default settings for range (autorange) and resolution (1
PLC) are used for the measurement.
MEASure:CURRent:DC? (@7043)
Configuring a Module
Example: Configuring a mod ule for 2-wire or 1-wire mode
command configures a MUX module in slot 4 for 1-wire mode. Because you can
configure only the 34923A and 34925A MUX modules (and the 34933A matrix
module) for either 2-wire or 1-wire mode, an error is generated if you send this
command to a slot that does not contain one of those three modules. If you are
using terminal blocks with these modules, be sure to use the corresponding
2-wire or 1-wire terminal block.
SYSTem:MODule:WIRE:MODE WIRE1,4
When using a command to configure the system, the new configuration does not
NOTE
take effect until you cycle power on the 34980A.
Example: Querying the system for mod ule Identify
returns the identity of the module installed in slot 7.
SYSTem:CTYPe? 7
For the 34923A and the 34925A MUX modules, the query response may include
NOTE
a suffix to indicate a 1-wire configuration. For example, the response for the
34923A will be either "34923A" (differential mode) or "34923A-1W"
(single-ended mode).
Keysight 34921A-34925A User's Guide
The following command configures
The following
The following command
15