– The simulation mode applies to the entire mainframe and cannot be selectively
– When the simulation mode is enabled, the Analog Bus relays will appear to
– The simulation setting is stored in volatile memory and will be lost when power
12
used on individual modules.
close and open as directed. For example, no errors are generated if you close
an Analog Bus relay from the front panel, remote interface, or Web Interface.
However, remember that the Safety Interlock feature prevents the actual
hardware state of the Analog Bus relays from being changed. When you
connect a terminal block or cable to the module, the Analog Bus relays will be
closed.
is turned off. To re-enable the simulation mode after power has been off, you
must send the command again.
Keysight 34921A-34925A User's Guide