Huawei IN200 User Manual page 55

Huawei IN200 NIC
User Guide
Step 3 Run the following command to access the /etc/sysconfig/network-scripts directory:
cd /etc/sysconfig/network-scripts
Step 4 Run the following command to create and open the ifcfg-fsb_bond configuration file:
vi ifcfg-fsb_bond
Press i to add the following information to the file:
DEVICE=fsb_bond
ONBOOT=yes
BOOTPROTO=none
USERCTL=no
TYPE=Bonding
MTU=1500
BONDING_OPTS='mode=1 miimon=100 updelay=0 downdelay=0 num_grat_arp=50'
NM_CONTROLLED=no
IPADDR=
NETMASK=
NETWORK=
After the modification is complete, press Esc to exit editing mode and enter :wq! to save the
modification and exit.
Step 5 This step uses ports enp8s0 and enp9s0 as an example to describe how to bind fsb_bond. In
the /etc/sysconfig/network-scripts directory, modify ifcfg-enp8s0 and ifcfg-enp9s0 and add
the MASTER=fsb_bond option.
For example, to edit the ifcfg-enp8s0 file, run the following command:
vi ifcfg-enp8s0
Press i to add the following information to the file:
DEVICE=enp8s0
BOOTPROTO=none
ONBOOT=yes
MASTER=fsb_bond
SLAVE=yes
USERCTL=no
NM_CONTROLLED=no
After the modification is complete, press Esc to exit editing mode and enter :wq! to save the
modification and exit.
Step 6 Run the following command to restart the network:
service network restart
----End
Issue 06 (2019-07-27)
NOTE
l Set the bonding mode and network check time in the BONDING_OPTS configuration item.
l If mode is set to 1, the switch is configured properly. If mode is set to 2, the switch must be
configured with a trunk. If mode is set to 4, the trunk of the switch must be configured to the static
LACP mode. It is recommended that the rate be set to the same value as that of bonding.
l If the bonding mode is set to 4 in the BONDING_OPTS item, you are advised to set lacp_rate.
Copyright © Huawei Technologies Co., Ltd.
5 Configuring RoCE Bonding
46