Preparing Oss Supported By The Roce Bonding; Configuring Roce Bonding - Huawei IN200 User Manual

Huawei IN200 NIC
User Guide
l

5.2 Preparing OSs Supported by the RoCE Bonding

Table 5-1 OSs supported by Huawei in-house OFED
OS
CentOS
RHEL
UVP
Ubuntu
EulerOS

5.3 Configuring RoCE Bonding

You can implement bonding by creating, destroying, and configuring bonding devices using
commands or a configuration file. NetworkManager is not recommended for bonding
configuration.
Prerequisites
The RoCE driver package of the IN200 NIC has been installed.
The VLAN has been configured.
Issue 06 (2019-07-27)
802.3ad mode4: IEEE 802.3ad dynamic link aggregation mode. You can create an
aggregation group that shares the same rate and duplex settings. Multiple devices can
work in the same aggregation group that has been activated based on 802.3ad.
Figure 5-2 shows Balance-XOR mode2 and 802.3ad mode4.
Figure 5-2 Balance-XOR mode2/802.3ad mode4
x86
7.4, 7.5, and 7.6
7.5 and 7.6
2.5.RC10.SPC110B055d
and 2.5.RC9.B057
18.04.1
V200R007C00SPC500B005
and
V200R005C00SPC310B056
Copyright © Huawei Technologies Co., Ltd.
5 Configuring RoCE Bonding
ARM
7.5 and 7.6
-
3.0.RC1.SPC800B050,
3.0.RC2.B033, and
2.5.RC8.SPC800.B010
18.04.2
2.2.RC3,
V200R008C00SPC100B220,
V200R008C00B180, and
V200R005C00SPC310B056
44