Configuring The Firmware Kernel - OEM BL2500 User Manual

PLC BL2500 User's Manual
EMBEDDED
5. On the Kernel License window, write down the
User Reference Code (you can select the code in
the User Reference Code and copy it to the
clipboard using Ctrl-C). Contact OEM
Technology Solutions or your local distributor to
obtain a valid license key. Remember to quote
the User Reference Code. Press Cancel. An
error message dialog is displayed, press OK and
close the
EMBEDDED
Note:
Even if your Target is not active (without valid license key) you can run several samples in
the ISaGRAF Workbench in simulation mode. To run those sample files go to Section 0.
6. Once you have a valid license key, open the
License... Follow the instructions on the message dialog box in the same order: Press OK → Reset
Target. After a few seconds the License Window will be displayed and the DS2 led (red) will be
turned on.
7. Enter the valid license key in the License Key entry box and press Send. A confirmation message is
displayed. Save the User Reference Code and License Key for future reference and technical
support. Press OK. The DS2 led (red) will be turned off and DS1 led (yellow) will start flashing every
second as an indication that the Kernel is licensed and active. For more information about the
BL2500 LED status see Section 4.6.

6.1.4 Configuring the Firmware Kernel

If you purchased an
EMBEDDED
TCP and the following TCP/IP values: IP address = 192.168.1.100, Netmask = 255.0.0.0, Default
gateway = 192.168.1.1. If you want to check or change the Target PLC configuration, follow these
instructions:
1. Open the
EMBEDDED
on the message dialog box in the same order: Press OK → Reset Target. After a few seconds the
Target Configuration Window is displayed.
OEM Technology Solutions
PLC Utility.
PLC Application Kit, the BL2500 comes pre-configured for Use Modbus
PLC Utility and select Setup → Target Configuration... Follow the instructions
Loading or Upgrading the Firmware Kernel
PLC Utility. Select Setup → Kernel
EMBEDDED
Page 50