Updating The Led Engine Software - Chroma Inspire XT User Manual

2.7

Updating the LED engine software

The software for the LED engine module of the Terminal Strip can be uploaded directly into the
fixture through the Uploader using an XLR5-to-Terminal Block cable adaptor. The upload process
can be performed to one fixture at a time only. (See diagram below)
1. Download and extract the current software revision from http://www.chroma-
q.com/support/downloads.asp under the "Software" column.
2. Connect the Chroma-Q Uploader to your PC.
3. Erase the previous file and copy the current hex file into the Uploader.
4. Connect the Uploader to the fixture with a XLR 5-pin to Terminal Block cable adaptor.
5. Power-up the fixture.
6. The Uploader display shows the software name and version, and "Ready".
7. Press the GO button once to execute the uploading.
8. The Red indicator light on the GO button blinks and the Uploader display shows a
simulated arrow indicating the uploading process.
9. All the green LEDs of the fixture will light up (low intensity) to indicate completion of a
successful Upload.
10. The Uploader display shows "DONE" upon completion of the upload.
11. Power-cycle the fixture.
12. Repeat step 6 to step 10 if the uploading process is interrupted (power and/or data).
(For more detail, see the Quick Start Guide of the Chroma-Q Uploader)
Inspire XT User Manual
Cable Adaptor:
XLR5 to Terminal Block
www.chroma-q.com
15 V1.2 July, 2019