Chroma Inspire XT User Manual page 10

Inspire™ XT fixture wiring:
To connect the wiring of the AC power input cable:
1. There is a Power Input Cover Plate provided with the fixture (Figure 2), and is not attached
to the fixture. The Power Input Cover Plate must be mounted as described in the following
steps.
2. To avoid pressure on connector and faulty connection, the power cable use should
be soft like SJOW cable type. Avoid rigid electrical cable.
3. Insert the power cable with the appropriate cable strain relief through the cover plate
4. Unplug the Terminal Block Plug from the Header and connect the wiring for the AC power
input through the hole and into the Terminal Block PLUG (Figure 3)
5. Plug the wired Terminal Block Plug into the Terminal Block Header (Figure 3)
6. Put the cover plate on as shown in the picture and fasten the cover plate with the two
screws provided with the light fixture
To connect the wiring of the control data cables:
1. Connect the wiring for the DMX control data cables (In/Out) into the Terminal Block Plugs
(Figure 4)
2. The control cable connected to the first Inspire XT fixture from each Data Output of the
External Control Box MUST be terminated with a 120 Ω resistor. For details, see Inspire
Terminal Strip DMX Cable Termination section on the next section.
3. Plug the wired Terminal Block Plugs into the Terminal Block Headers (Figure 4)
Note: The control cable connected to the first fixture from each data output MUST be terminated
with a 120 Ω resistor. Terminal blocks with resistors installed are included in the External Control
Box. See Inspire™ XT Data Cable Termination on the next section.
Figure 2 Bottom View of the Fixture
Inspire XT User Manual
www.chroma-q.com
9 V1.2 July, 2019