Table of Contents
Advertisement
Section 3
This section describes how to power up and shut down your Cobra system,
access the Scan-X software and its on-line Help, raise and lower the sensor,
perform a scan, and optimize laser settings.
Powering Up Your System
After unpacking your Cobra and installing the Scan-X software on the
associated computer (if applicable), you are ready to power up your Cobra
system.
To do so, follow the steps below.
1.
2.
3.
Your Cobra system is powered up and ready to use.
Note: You can perform a normal system shutdown by exiting Scan-X and
Windows, turning off the computer and monitor, and then turning off Cobra.
Getting Started
Turn on the computer and monitor.
Turn on your Cobra. The power switch is located in the upper-right corner
on the Cobra back panel as shown in Figure 3-1.
Figure 3-1. Power Switch Location
Access Scan-X by using one of the following methods:
-
Double click on the Scan-X icon, located on the Windows desktop
-
Left click on the Scan-X icon, and then right click and select Open
from the pop-up menu
-
Click on the Start button, and then select Programs
Scan-X
Getting Started
Scan-X
3-1
Advertisement
Table of Contents
