Mounting The Video Camera And Lcd Screen Assemblies; Tools And Materials Required; Mounting Procedure - QVI Cobra DRS-300 User Manual

Mounting the Video Camera and LCD Screen Assemblies

Tools and Materials Required

Mounting Procedure

2-6
This subsection only applies to Cobra 2D systems equipped with the video
camera option. The procedure outlined below assumes that Steps 1 through 4 of
the Mounting and Setting Up Cobra 2D procedure have already been completed.
If they have not, they must be completed before starting this procedure.
Note: The video camera option can only be used with the DRS-300 and
DRS-500 lasers; it cannot be used with the DRS-2000 or DRS-8000 lasers.
To mount the video camera and LCD screen assemblies onto your Cobra you
will need the following:
•
2 mm hex key (Allen) wrench
•
3 mm hex key (Allen) wrench
•
5/32" hex key (Allen) wrench
•
Small flat-head screwdriver
To mount the video camera and LCD screen assemblies, follow the steps below.
1. Unpack the video camera
accessory package. The
package includes the camera
and LCD screen assemblies,
three partially-threaded
screws, and the
interconnecting cables.
2. Use a 2 mm hex key (Allen)
wrench to remove the four
screws securing the camera
cover to the camera
assembly (see Figure 2-4).
Figure 2-4. Removing the Camera Cover
Installation and Setup