Unpacking And Setting Up Cobra 3D; Tools And Materials Required; Support Surface Requirements - QVI Cobra DRS-300 User Manual

Unpacking and Setting Up Cobra 3D

Tools and Materials Required

Support Surface Requirements

2-14
This subsection only applies to Cobra 3D. See the topic, Unpacking and Setting
Up Cobra 2D, for information on how to unpack and set up Cobra 2D.
When you receive your Cobra 3D, the shipment will consist of a bounded pallet
containing the Cobra 3D and any optional accessories. Your Cobra 3D will be
fully assembled, so all you need to do is unpack it, set it on a stable support
surface, and connect it to the associated computer.
To unpack and set up your Cobra 3D system, you will need the following:
•
Fork lift or pallet jack
•
Power or manual hoist capable of lifting 80 kg (175 lbs)
•
Pair of diagonal cutters
•
Parallel cable
•
Heavy-duty desk, workbench, table, or other surface (see minimum
requirements below)
Cobra 3D can be set up and used on any flat, stable surface. Place Cobra 3D on
a heavy-duty desk, workbench, table, or other surface to increase the accuracy
and repeatability of your measurements.
The support surface should:
•
Not vibrate or shift when you lean on it, or move the stage
•
Be able to safely support the full system and parts being scanned - a weight
capacity of 90 kg (200 lbs) is recommended
•
Have a work area of at least 110 x 110 cm (42 x 42")
Installation and Setup