Table of Contents
Advertisement
Electrical Safety
The Cobra DRS control module and sensor operate at low voltages and power
levels. However, observe the following precautions regarding electrical safety.
Power and Grounding
Your Cobra is grounded through the power cord. To avoid electric shock, plug
the power cord into a properly wired receptacle with an earth ground
connection.
A protective ground connection is essential for safe operation of your
Cobra.
Power Cord
Follow these general safety rules regarding your Cobra's power cord:
•
•
•
Servicing
Cobra servicing should only be performed by qualified personnel.
Do not remove Cobra's bottom panel to expose internal components. This is
a high voltage area that should only be accessed by an authorized service
representative. Contact your authorized service or sales representative for
assistance.
Liquids
Keep water and other liquids away from your Cobra, to reduce the risk of
spillage and electrical shock.
For Your Safety
Use only the power cord and connector supplied with your Cobra. If you
must use an extension cord, make sure it is grounded and is of the proper
type and wire gage.
Do not operate your Cobra if the power cord is damaged.
Position the power cord so that it will not be tripped over, pulled, or come in
contact with a hot surface.
vii
Advertisement
Table of Contents
