Table of Contents
Advertisement
Cable Connections
2-10
10. Reinstall the camera
cover (using the screws
removed in Step 2).
11. Screw the LCD screen
assembly onto the Cobra
handle. Use a 5/32" hex
key (Allen) wrench to
tighten the mounting
screw (see Figure 2-9).
12. Follow the procedure
described next to make
the necessary cable
connections.
After mounting the camera and LCD screen assemblies, follow the steps below
to make the necessary cable connections.
1.
Locate the Camera and LED Power cable, and then connect J2008 to the
LED CTRL port on the Cobra back panel (see Figure 2-10). Use a small
flat-head screwdriver to tighten the two screw-locks (one on each side of the
connector) firmly.
Figure 2-10. Connecting J2008 to the Back Panel
Figure 2-9. Installing the LCD Screen Assembly
Installation and Setup
Advertisement
Table of Contents
