Unpacking And Setting Up Cobra 2D; Tools And Materials Required; Unpacking Procedure - QVI Cobra DRS-300 User Manual

Unpacking and Setting Up Cobra 2D

Tools and Materials Required

Unpacking Procedure

2-2
This subsection only applies to Cobra 2D. See the topic, Unpacking and Setting
Up Cobra 3D, for information on how to unpack and set up Cobra 3D.
When you receive your Cobra 2D, the shipment will consist of a box that
contains the main unit, individually wrapped laser sensor(s), and video camera
package (if applicable). The laser sensor(s) is not attached to the main unit.
Note: The shipment will include additional boxes if you also purchased the
Factory-supplied Computer option.
The procedure for unpacking Cobra 2D and mounting the laser sensor onto the
unit is outlined below.
To unpack and set up your Cobra 2D system, you will need the following:
•
3 mm hex key (Allen) wrench
•
Utility knife
•
Machinist square or other quality square tool
•
Parallel cable
•
Workbench (optional)
To unpack and set up your Cobra 2D, follow the steps below.
Note: This procedure assumes that if you are supplying your own computer,
the computer is already set up and ready to be connected to Cobra.
1. Remove the laser sensor box and the Cobra Laser Profile Scanner from the
main shipping carton.
2. Place Cobra on a sturdy work surface.
Note: For optimum performance, we recommend placing Cobra on a granite
surface plate.
Installation and Setup