Sahara -Pak HC-1260 Instruction Manual page 7

INSTRUCTION MANUAL
Model HC
1.0.1 Dryer Location and Mounting Specifications (continued)
1.0.1.3
1.0.1.4
1.0.1.5
1.0.1.6
1.0.1.7
1.0.1.8
1.0.1.9
1.0.1.10 Ground the frame of the dryer in accordance with the end
1.0.1.11 Disconnect switch is not provided with the dryer and must be
Reference 219
Page 7 of 46
Locate the dryer in the coolest possible location, providing
adequate space around the dryer for servicing all components.
An overhead clearance of not less than three feet above each
tower is required for loading of the desiccant. Access
clearance of three feet in front of the control panel should be
provided. For mounting dimensions, refer to the general
assembly drawing in Section 8.
Remove all protective shipping crates, flange covers, etc.
Utilizing the mounting holes provided on the skid, anchor the
HC dryer to a solid, level foundation designed to support the
dryer. Should vibrations occur on the installation location, the
dryer is to be placed onto vibration dampeners.
Because of vibration during shipping and installation, some
lines, fittings, bolts, and connections may have loosened;
therefore, inspect all and tighten if required.
Locate and install any items that may have shipped loose from
the dryer, such as exhaust mufflers or auxiliary filters.
If desiccant has been shipped separate and must be installed,
reference Section 2 for desiccant installation instructions and
Section 7 for the Material Safety Data Sheet (MSDS). Wear
protective goggles and mask when working with desiccant.
Connect the dryer to a correctly sized power supply. The
standard HC dryer requires a 115V, 60 cycle connection. For
voltage and current requirements, refer to the Specifications in
Section 5.
user's local electrical codes.
supplied by the end user with proper overload protection
according to local electrical codes.
Rev 2
06/20/2013