General Use; Main - Sahara -Pak HC-1260 Instruction Manual

ALLEN-BRADLEY PANELVIEW COMPONENT C400
OPERATIONAL GUIDE
B.

General Use

 Turn ON/OFF switch to the ON position.
 Power On. Indication is provided by the operator interface. When the dryer is
on, the interface is on. After 30 minutes of idle time, the interface enters a
sleep mode; however, in this mode an Allen-Bradley logo is shown slowly
moving around the screen to indicate the unit is active. Touch anywhere on
the screen to exit sleep mode.
 8-hour NEMA cycle; will result in lower dew points. The half cycle time is
indicated on the SETTINGS screen. The cycle length will not change until the
next tower shift.
 Left or Right Tower Online. The tower that is onstream is shown on the
STATUS screen.
NOTE: All screens are reviewed further in the following sections.
C.

Main

This screen is the start-up screen. The display will go directly to this screen upon
power-up.
The MAIN screen displays the model and serial number of the dryer. It also has
contact information for Henderson Engineering, should you need assistance with
the dryer.
A screen selector list is located at the right of the touch screen and is used to
navigate to the other screens. Use the up or down arrow keys to select a screen
name, then press the enter key.
Reference 230 – for use with Sahara Model HC Heat-of-Compression – no heater
Page 4 of 17
Rev 2
10/17/2013