Adjustments; Desiccant; Replacement / Disposal Of Desiccant - Sahara -Pak HC-1260 Instruction Manual

INSTRUCTION MANUAL
Model HC

2.1.2 Adjustments

The inlet air temperature (as indicated on the Instrument Panel) should
be adjusted to obtain the desired temperature/dew point performance
(refer to Specifications in Section 5). This can be accomplished through
manipulation of the inlet piping insulation and/or the compressor
intercooling.
The temperature of the air leaving the dryer aftercooler should be
maintained at or below 90F. Adjust the cooling water supply as required.

2.1.3 Desiccant

2.1.3.1
Reference 219
Page 28 of 46

Replacement / Disposal of Desiccant

The dryer is filled from the top and emptied from the bottom.
Refer to the General Assembly drawing in Section 8 for
location of fill and drain ports.
Advice for protection:
 If desiccant comes into contact with the eyes, rinse eyes
immediately with large amounts of clear water.
 If the desiccant is spilled, clean up with effort to minimize the
formation of dust.
 In case of fire, there is no restriction on the use of fire
extinguishing material.
 A small dust mask must be worn.
Rev 2
06/20/2013