ALLEN-BRADLEY PANELVIEW COMPONENT C400
OPERATIONAL GUIDE
G.
Settings (continued)
This screen allows you to adjust the factory presets. SET END HEAT allows you
to adjust when the heat cycle will end; the factory preset is 90. SET END STRIP
allows you to adjust when the stripping cycle will end; the factory preset is 180.
The SET LOW REGEN allows you to adjust the temperature for the low regen
alarm; the factory preset is 225°F/107°C. SET HIGH COOLER OUTLET allows
you to adjust the high cooler outlet alarm; the factory preset is 105°F/40°C.
This screen allows you to toggle between HC and HL mode. The mode will not
change, until the current half cycle is finished.
Reference 230 – for use with Sahara Model HC Heat-of-Compression – no heater
Page 9 of 17
Rev 2
10/17/2013