Table of Contents
Advertisement
INSTRUCTION MANUAL
Model HC
SECTION 2:
2.0
Operation
Never make any changes to the dryer that are not specifically authorized
by Henderson Engineering Co., Inc.
Only use original spare and accessory parts.
Carry out maintenance work only when the dryer is switched off,
depressurized (even though gauges may read 0, there may still be air in
the dryer), and disconnected from the electric power supply.
Multiple power sources may exist in the electrical panel. All possible
power sources must be disconnected before servicing dryer.
2.0.1 General Information
The HC dryer is used for the purpose of drying compressed air and other
gases according to its respective design. As a "standard model" the dryer
is equipped with two desiccant vessels and, depending on certain
conditions, provides pure, dry, and oil-free compressed air or gases.
The HC dryer is built according to the latest technological developments.
Its use can endanger personnel and can lead to considerable damage to
the dryer and other material assets if:
it is operated by personnel not trained or instructed in its use
it is improperly used
it is improperly maintained or serviced
This can result in the loss of all damage claims.
This dryer is designed for neutral media (gas) free of aggressive water,
oil, and solid elements. Henderson Engineering Co., Inc., accepts no
liability for corrosion damage and malfunctions caused by aggressive
media.
Applications other than those mentioned in this manual must be agreed
to by Henderson Engineering Co., Inc., and confirmed in writing.
Reference 219
Page 17 of 46
OPERATION & MAINTENANCE
Rev 2
06/20/2013
Advertisement
Table of Contents
Troubleshooting
