Hach NO3D sc User Manual page 21

4.5 Sensor setup menu (continued)
CALIBRATE(continued)
CAL.CONFIG.>
VALUE CORR
-or-
CAL.CONFIG.>
PREVIOUS CAL
-or-
CAL.CONFIG.>
FACTORY CAL
DATE
SENSOR CODE
CONFIGURE
EDIT NAME
MEAS UNITS
SET PARAMETER
TEMP UNITS
TEMP CORR
RESPONSE TIME
LOG SETUP
CL- COMPENSATE.
SET DEFAULTS
Value correction (see section 4.6.3.5 on page
Once value correction is complete, the correction data are displayed in the form of
the MATX2
1st NO3–N NO3DSC
1st CL- NO3DSC
1st NO3–N LAB
2nd NO3–N NO3DSC
2nd CL- NO3DSC
2nd NO3–N LAB
Selection of one of the last four matrix and value corrections performed
Selection of the preset sensor code
Date of last calibration
Enter the sensor code
Entry or editing of the name. Up to 10 alphanumeric characters.
Selection of mg/L or ppm as measurement unit
Selection of NO –N or NO
3 3
Selection of °C or °F as temperature unit.
Entry of the temperature correction (–1.5 to +1.5 °C or –2.7 to +2.7 °F)
Entry of the response time (30 sec to 300 sec)
Selects the interval for the data logging
(deactivate, 1, 2, 5, 10, 15, 30 min, 1, 2, 6 hr).
Selection of the chloride compensation: On, off or fixed value
Resets the configuration on the factory setting.
27)
Enter the NO –N concentration (NO3D sc) of
3
the 1st point
-
Enter the Cl concentration (NO3D sc) of the
1st point
Enter the NO –N concentration (lab) of the 1st
3
point
Enter the NO –N concentration (NO3D sc) of
3
the second point
-
Enter the Cl concentration (NO3D sc) of the
second point
Enter the NO –N concentration (lab) of the
3
second point
Operation
21