Metronome Parameters - Kurzweil Flash Play PC4 Musician's Manual

Song Mode
The MISC Page
Grid
The grid parameter determines the resolution of quantization and the position of the grid
points.
Swing
The Swing parameter determines the amount (in units of percent) of "swing" applied during
quantization.
Release
The Release parameter determines whether or not note-off events are quantized.

Metronome Parameters

Metronome
This parameter determines the recording modes in which the metronome plays. With
Metronome set to Off, the metronome never plays. With Metronome set to Rec, the
metronome only plays during recording. With Metronome set to Always, the metronome
plays during playback and recording. With Metronome set to CountOff, the metronome
plays only during count off (if the CountOff parameter is set to something other than Off.)
Count Off
This parameter determines the number of measures the PC4 will count off before recording.
With Start Only selected, the PC4 will only count off at the beginning of a sequence. With
Always selected, the PC4 will count off from any point in a sequence.
Program
This parameter determines the program with which the metronome is played.
Channel
This parameter determines the MIDI channel to which the metronome program and events
are sent.
Strong Note
This parameter determines the MIDI number of the note played by the metronome for the
first beat of each measure.
Strong Velocity
This parameter determines the velocity of the note played by the metronome for the first beat
of each measure.
8-18