Common Parameters For Track Functions; From And To; Events - Kurzweil Flash Play PC4 Musician's Manual

Hide thumbs Also See for Flash Play PC4:
Table of Contents

Advertisement

Song Mode
The TRACK Page

Common Parameters for Track Functions

Locate
This parameter is available for every function on the TRACK page. It appears at the lower
left hand corner of the page.
The Locate bar, beat, and tick will change in real time during playback and recording to
reflect the song's current position. It can be set to any bar, beat, and tick. Playback begins at
this position, and Stop resets the song to this position.

From and To

From and To are available in most TRACK edit functions to define a range of time on
the selected track(s). The From value defines the first bar, beat, and tick in a range of time
selected for editing. The To value defines the final bar, beat, and tick in a range of time
selected for editing.

Events

Use the Events parameter to select the type of MIDI event to edit. Available Event types are:
All, Notes, Velocity, Controllers, MonoPress, PitchBend, ProgChange, PolyPress. Some event
types are available only for certain Functions.
When Events is set to All, all MIDI events on the track(s) you are editing that occur in the
region of time between the From and To settings will be affected by the edit function.
When Events is set to Notes, note number and velocity ranges can be set for Note events.
(Some Functions may not provide velocity range parameters).
When Events is set to Velocity, the velocity range can be set for Note events.
When Events is set to Controllers, the Controller and Value Range can be set for Controller
events.
Key Range
The left and right Key Range fields respectively determine the lowest and highest notes in a
range of notes that will be affected by the selected Track Function.
Velocity Range
The left and right Velocity Range fields respectively determine the lowest and highest
velocities in a range of velocities that will be affected by the selected Track Function.
Controller
The Controller parameter selects the Controller (or All Controllers) to be affected.
8-24

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents