The Envelope 2 (Env2) And Envelope 3 (Env3) - Kurzweil Flash Play PC4 Musician's Manual

The Envelope 2 (ENV2) and Envelope 3 (ENV3)

Pages
Use the Envelope 2 and Envelope 3 pages to adjust the envelopes 2 and 3 for each layer.
Unlike the amplitude envelope, which always controls the volume contour of each note
played, envelope 2 and 3 are control sources which have no affect until they are assigned to
modulate a parameter in the layer. For example, envelope 2 is commonly used to modulate
filter frequency, but can be assigned to modulate any parameter in the layer.
The envelope 2 and 3 parameters are the same as the amplitude envelope parameters, with a
few exceptions:
ENV2 and ENV3 are bipolar, envelope values can be set from -100% to 100%.
The ENV2 and ENV3 attack segments are linear, meaning the attack segments increase
at the same rate from start to finish. (AMP ENV uses an exponential attack, meaning the
amplitude rises much faster at the end of the attack segment than it does at the beginning.)
The ENV2 and ENV3 Rel3 segment can be set to values from -100% to 100%, unlike the
AMP ENV Release3 segment which always returns to 0%.
ENV2 and ENV3 do not have envelope control parameters.
See "The Amplitude Envelope (AMP ENV) Page" on page 3-60
parameter.
The Envelope 2 (ENV2) and Envelope 3 (ENV3) Pages
Program Edit Mode
for details on each envelope
3-65