Technical Support / Service; Accessories - Labnet ProBlot 6 Instruction Manual

Hybridization systems
Table of Contents

Advertisement

TROUBLESHOOTING GUIDE (continued)
PROBLEM
Temperature is too low
Unit will not heat above temperature
that is below set point
Temperature display and reference
thermometer do not match
Can not adjust set point or calibration
Unit calibrated at one temperature
load not at another

TECHNICAL SUPPORT / SERVICE

Should your ProBlot hybridization oven require service, call Labnet International's Service Depart-
ment at 732-417-0700 between the hours of 9:00am and 5:00pm EST. If service necessitates the
return of the unit to Labnet's Service Department, a return authorization (RA) number must first be
obtained and a decontamination certificate completed. The unit must be thoroughly decontami-
nated before shipping. The unit must then be sufficiently packed for shipment. Any shipping dam-
age on returned units will be the customer's responsibility.

ACCESSORIES

B3003
Large 300x35mm bottle w/cap
B3003-PC
as above with safety coating
B3003-DC
Large bottle with caps on both ends B1124
B2503
Medium 250x35mm bottle
B1503
Small 150x35mm bottle w/cap
B1503-PC
as above with safety coating
B2753
Small bottle with 2 x75mm chambers B1507
H1200-RA
Rocking platform
H1200-250A Clamp platform 6 x 250ml flasks
H1212-40VA Rotisserie 12 x 50ml tubes, vertical
POSSIBLE SOLUTION
If door has opened, unit may not have recovered yet.
Confirm temperature set point.
Confirm set point. Check temperature of chamber
with a thermometer and recalibrate if needed.
Be sure that unit has been allowed to stabilize for
1 hour. Thermometer should be suspended in
rotating bottle and not touching bottle surface. Only
certified reference thermometers should be used.
Turn unit off for 5 seconds to reset. If problem
persists call service
This can be a normal condition if temperatures or
vary widely. For best accuracy, calibrate at set point
B1500-CAP
B2500-SEAL Seal for all 35mm bottles
H9088
H9089
B0753
B3007
H1204-80A
Cap for 35mm bottles
Rack for 6 35mm bottles
Mesh 23x23cm (pack of 5)
Mesh 10x15cm (pack of 5)
Small 75x35mm bottle
150x70mm bottle, vented
300x70mm bottle, vented
Rotisserie 4 x 70mm bottles

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ProBlot 6 and is the answer not in the manual?

This manual is also suitable for:

Problot 12Problot 24Problot 12s

Table of Contents