Appendix; Example Contents Of The Acceptance Test; Overview; Sinumerik 828D With Safety Integrated - Siemens SINUMERIK 828D Function Manual

Appendix

A.1

Example contents of the acceptance test

A.1.1

Overview

Note
Recommendations and suggestions for the content and scope of the acceptance tests (various
systems) are listed in this Chapter. The machine manufacturer is responsible for carrying out
and documenting an acceptance test.
The acceptance report is divided into the following sections:
● Plant/system description
● Description of the safety functions
● Test of safety functions
A.1.2

SINUMERIK 828D with Safety Integrated

1)
1.1
1.2
1.3
1.4
1.5
1.6
2)
2.1
2.2
SINUMERIK Operate acceptance test
Function Manual, 08/2018, A5E39460574B AC
DOCUMENTATION
Documentation of the machine including the safety functions
Machine description (with overview diagram)
Details about the control system
Configuration diagram
Function table
Active monitoring functions depending on the operating mode, the protective doors and
other sensors.
It makes sense that this table is part of the documentation of the engineering work that
has been carried out.
SI functions per axis
Information and data about safety equipment
FUNCTION TEST PART 1
General function test, including a check of the wiring/configuring
Testing the switch-off signal paths
Testing the forced checking procedure of the switch-off signal paths
Testing the forced checking procedure of the inputs and outputs
A
85