Generating And Saving An Acceptance Report - Siemens SINUMERIK 828D Function Manual

Supplementary functions
● Full screen
Hides the list of the setting areas and displays the detail settings of the currently selected
setting area over the complete screen width.
● Load template (Page 67)
Loads a template (XML format) that was created externally.
● Export template (Page 67)
Exports the current acceptance test as template (in the XML format). The template contains
a list of all of the implemented tests that must be carried out for the acceptance test. Further,
all of the texts of the complete acceptance test are included; e.g. details about the machine
on the overview page.
● Save results (Page 70)
Saves the results (*.atw) in a directory.
● Load results (Page 70)
Loads the saved results from a directory. This function is useful if the test is exited before
completion and you wish to continue at the position where you left off.
● Start new test
Starts an additional test in the currently displayed setting area.
● Repeat test
Repeats a selected test in the currently displayed setting area.
● Delete test
Deletes the currently marked test.
● Go to overview
Jumps from the current setting area into the "Overview" setting area.
● Finish
Skips the following setting area and jumps directly to the "Finished" setting area.
● Display trace
Displays a trace.
● Exit the SI acceptance
Exits the acceptance test for the Integrated Safety Functions
3.3.4.2

Generating and saving an acceptance report

The following example shows the typical procedure for generating the acceptance report.
SINUMERIK Operate acceptance test
Function Manual, 08/2018, A5E39460574B AC
Acceptance test wizard of SINUMERIK Operate
3.3 SINUMERIK 840D sl - system-integrated Safety Functions
59