Installation sequence
Thermal insulation on the Vitocell with...
Note
2 people are required for the following work.
1. At the back of the cylinder: Attach 6 clip fasteners
to the edges of the right and left sections of the
thermal insulation jacket. Place the thermal insula-
tion jacket around the cylinder body.
Note
Leave the clip fasteners in the first notch.
Closing the thermal insulation and fitting the cover strips
2.
Fig.15
1. Tighten the nuts on the bolts.
2. Trim and fit the cover strip.
18
(cont.)
2. Fit 4 clip fasteners above and 2 clip fasteners
3. Push the clip fasteners as close together as possi-
3.
1.
3. Insert the rear sections of the Vitotrans thermal
behind the Vitotrans so that they are evenly
spaced.
ble.
insulation. Observe the groove in the thermal insu-
lation.