Miele CS 1212-1 Operating And Installation Instructions page 8

Warning and Safety instructions
Miele can only guarantee the safety of the appliance when genu-

ine original Miele replacement parts are used. Faulty components
must only be replaced by Miele spare parts.
The hob is not intended for use with an external timer switch or a

remote control system.
If the plug is removed from the connection cable or if the cable is

supplied without a plug, the appliance must be connected to the
electrical supply by a suitably qualified electrician.
If the mains connection cable is damaged, it must be replaced

with a special connection cable by an electrician (see "Electrical
connection").
The hob must be disconnected from the mains electricity supply

during installation, maintenance and repair work. Ensure that power
is not supplied to the appliance until after it has been installed or un-
til any maintenance or repair work has been carried out.
Danger of electric shock. Do not use the hob if it is faulty, or if the

ceramic surface is cracked, chipped or damaged in any way. Switch
it off immediately. Disconnect the hob from the mains electricity sup-
ply. Contact Miele Service.
If the hob is installed behind a cabinet door, do not close the door

while the hob is in use. Heat and moisture can build up behind the
closed door. This can result in damage to the hob, the housing unit
and the floor. Do not close the door until the residual heat indicators
go out.
In areas which may be subject to infestation by cockroaches or

other vermin, pay particular attention to keeping the appliance and
its surroundings clean at all times. Any damage caused by cock-
roaches or other vermin will not be covered by the warranty.
8