Chapter 1 Gre Configuration Commands; Gre Configuration Commands; Aggregation-Group - H3C S9500 Series Command Manual

Command Manual – GRE
H3C S9500 Series Routing Switches

Chapter 1 GRE Configuration Commands

1.1 GRE Configuration Commands

1.1.1 aggregation-group

Syntax
aggregation-group aggregation-group-ID
undo aggregation-group
View
Tunnel interface view
Default Level
2: System level
Parameters
aggregation-group-ID: Service loop group ID.
Description
Use the aggregation-group command to specify the service loop group to be applied
to a tunnel.
Use the undo aggregation-group command to remove the configuration.
By default, no service loop group is applied to a tunnel.
Before applying a service loop group to a tunnel in tunnel interface view, you need to
configure the service loop group in system view and set its service type to tunnel.
Related commands: link-aggregation group.
Examples
# Create service loop group 1. Then, set the configuration mode to manual and the
service type to tunnel.
<Sysname> system-view
[Sysname] link-aggregation group 1 mode manual
[Sysname] link-aggregation group 1 service-type tunnel
# Add the interface GigabitEthernet 4/2/1 to service loop group 1.
[Sysname] interface GigabitEthernet 4/2/1
[Sysname-GigabitEthernet 4/2/1] stp disable
[Sysname-GigabitEthernet 4/2/1] port link-aggregation group 1
Chapter 1 GRE Configuration Commands
1-1