Mpls Te Fast-Reroute - H3C S9500 Series Command Manual

Command Manual – MPLS TE
H3C S9500 Series Routing Switches
Use the undo mpls te cspf timer failed-link command to restore the default.
Related commands: mpls te cspf.
Examples
# Set the failed link timer to 50 seconds.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te cspf timer failed-link 50

1.1.59 mpls te fast-reroute

Syntax
mpls te fast-reroute
undo mpls te fast-reroute
View
Tunnel interface view
Default Level
2: System level
Parameters
None
Description
Use the mpls te fast-reroute command to enable fast reroute (FRR).
Use the undo mpls te fast-reroute command to disable FRR.
By default, FRR is disabled.
After FRR is enabled, the record route flag is automatically set to record reroute with
label whether the mpls te record-route label command is configured or not.
Disable FRR before configuring the mpls te record-route command or its undo form.
Note:
Fast reroute cannot be used together with the mpls te resv-style ff command.
Chapter 1 MPLS TE Configuration Commands
1-79