Table of Contents
Advertisement
Kendrion Kuhnke Automation GmbH
5 Installation and Operation
Information
Before installing, servicing or putting Kuhnke Vico into operation, please also read the safety
information in the preface of this document.
5.1 Mechanical Installation
Kuhnke Vico is a modern electronic assembly. Handle - specifically mount, operate and service - with care.
The unit is operated by means of a touch screen or, more specifically, a resistive touch screen.
Touch screens consist of multiple circuit layers made of different materials. Each of these layers will
therefore respond differently to changing climatic or mechanical conditions.
Whereas resistive touch screens are generally very tough, you should still take account of a couple of basic
facts when installing them.
5.1.1 Location of installation
The unit was not made for ongoing exposure to direct sunlight because this may make the film on the front
panel age faster.
The unit was not made for ongoing contact to corrosive chemical compounds and solvents. Check if the front
panel will resist them before you install it.
Do not use any sharp tools (screwdriver etc.) to operate the touch screen surface.
5.1.2 Mounting position
Only install the units as described below. Data sheet information assumes installation in a metal mounting
panel such as a cabinet door.
CAUTION
Risk of overheating and fire!
Even if operated at admissible ambient temperature, the unit may be destroyed if the way of
installation stops the convection cooling from working.
Please take heed of the notes on the mounting position
Leave some free space above, beneath, at the sides and back of the unit to allow enough air to circulate. Be
sure to leave at least 50 mm of free space on all sides. This specification applies to all variants.
Kuhnke Vico (E 854 DE)
28-03-2019
Construction and Functionality
23
Advertisement
Table of Contents
