Instruction Manual
IM-105-4000, Rev 1.3
October 2008
Figure 2-13. P1 and P2 Pin
Designations
Duplexer and AC power Supply
1. Connect the line wire (terminal 11 of the control unit) to an AC power
source.
2. Connect the neutral wire (terminal 12 of the control unit) to an AC power
source.
3. The transceiver blower is factory wired to the duplexer.
4. Plug the retro reflector blower into an AC power source.
5. Plug the service module into the duplexer.
6. Plug the duplexer into an AC power source.
OPM 4000
2-17