Removal Of Flywheel Magneto - Yamaha SL292C 1971 Service Manual

I
l
'
•
I
'
i
I
I
I
t
i
I
!
I
I
I
I
J
I
•
•
•
2-5 REMOVAL OF FLYWHEEL MAGNETO
2-5-1
With the starter assembly removed you will now be able to
remove the magneto assembly. The first step in this
procedure is to remove the flywheel securing nut. Use a
socket wrench (26 mm).
(In thi s case, to loosen or tighten the flywheel the ''bar''
should be inserted into the ho le in the pulley .)
Fig . 2-53
2-5-2
Remove the t hree bo lts tt1at hold the starter pulley, Once
these bol t s are removed, the pu I ley can be set aside.
Fig. 2-54
ENGINE -
Removal of Flywheel Magneto
2-5-3
The magneto flywheel can now be removed. This requires
the use of special puller that you will
find
in our special
tool kit. Be sure to use the three short screws that come
with the puller when removing the flywheel.
Note:
Immediately after the flywheel is removed, take the
woodruff key off the shaft and in same satisfactory
way attach it to the flywheel so that it is not lost.
Fig. 2-55
2-5-4
All parts of the magneto assembly, except for the magneto
backing plate, have been removed. The only time that the
magneto backing plate need be removed is in the case of
complete engine teardown. The backing plate has to be
removed in order to split the cases and this is accomplished
by removing the four hold-down screws, with an impact
screw driver.
Fig. 2-56
•
•
-27-
•
•
•