Ping; Network Connectivity Test (Ping Tool) - TRENDnet PoE Web Smart Switch Series User Manual

TRENDnet User's Guide

Ping

Network Connectivity Test (Ping Tool)

Tools > Ping
This chapter provides the procedure to ping a node on your network from the switch.
This procedure is useful in determining whether an active link exists between the switch
and another network device.
The device you are pinging must be a member of the Default VLAN and within the same
local area network as your switch. In other words, the port on the switch through which
the node is communicating with the switch must be an untagged or tagged member of
the Default VLAN.
1. Log into your switch management page (see
on page 5).
2. Click on Tools and click on Ping.
3. Review the settings. Click Start to start the network connectivity ping test. After the
ping test is activate, you can click Show Ping Results to check the ping test result.

Destination IP Address - The IP address of the node you want to ping in the
IPv4 or IPv6 format.

Timeout Value - Specifies the length of time, in seconds, the switch waits for a
response before assuming that a ping has failed.

Number of Ping Requests - Specifies the number of ping requests you want the
switch to perform.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
PoE Web Smart Switch Series
104