Add Ipv6 Neighbors - TRENDnet PoE Web Smart Switch Series User Manual

TRENDnet User's Guide

NS Retransmit Time: A constant that defines a nonzero number of seconds
between periodic reauthentication of the client. The field is 1~3600 seconds.
The default setting is 1 second.

Delete: Click Delete to delete this entry.
6. At the bottom of the left hand panel, click Save.
7. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2018 TRENDnet. All Rights Reserved.

Add IPv6 neighbors

System > L3 Feature > IPv6 Neighbor
This settings allows you to manually define IPv6 supported neighboring devices on your
network.
1. Log into your switch management page (see
on page 5).
2. Click on System, L3 Feature, and then IPv6 Neighbor.
3. Review the settings. When you have completed making changes, click Apply to save
the settings.

Neighbor IPv6 Address: Specifies the neighbor IPv6 address.

Link Layer MAC Address: Specifies the link layer MAC address.
Click Add to save the entry to the list.

You can type in the specific address and click Find to find the entry to modify or
click Delete or delete the address. If the entries span multiple pages, you can
navigate page number in the Page field and click Go or you can click First,
Previous, Next, and Last Page to navigate the pages.
PoE Web Smart Switch Series
"Access your switch management page"
12