Display messages
Possible causes/consequences and
&
* The on-board electrical system voltage is too low.
inoperative Battery low
¥
* The washer fluid level in the washer fluid reservoir has dropped below the minimum.
Top up washer fluid
Lights
Display messages
Possible causes/consequences and
b
* The corresponding light source is defective.
Left dipped beam
(example)
The stationary heater has switched itself off.
Drive for an extended period until the battery has reached a sufficient charge level again.
#
Top up the washer fluid (
page 374).
→
#
Consult a qualified specialist workshop.
#
or
Check whether you are permitted to replace the light source yourself (
#
%
LED light bulbs: the display message for the corresponding lamp appears only when all the light-emitting diodes
in the lamp have failed.
Display messages and warning/indicator lamps 503
M M
Solutions
M M
Solutions
page 145).
→