Sony PDW-530 Operation Manual page 66

SHUTTER selector
The current shutter setting indication appears for about
3 seconds in the setting change and adjustment
progress message display area of the viewfinder
screen.
Examples: ": SS : 1/250", ": SLS : 8FRAME", ": ECS
: 60.0 Hz"
3
Before the shutter setting indication disappears, push
the SHUTTER selector down to SELECT again and
repeat this until the desired mode or speed appears.
Pushing the SHUTTER selector down to SELECT
repeatedly allows you to cycle through the settings of
mode and speed preselected on the SHT ENABLE
page of the OPERATION menu.
Note that all modes and all standard-mode speeds
listed in the table on page 65 are preselected using the
SHT ENABLE page of the OPERATION menu.
By factory default, all available shutter modes and
shutter speeds are displayed in the sequence shown in
the following figure. (You can use the SHT ENABLE
page of the OPERATION menu to make a setting so
that only the desired (or most frequently used) modes
and speeds are displayed.)
Standard mode
SLS mode
1/100: for PDW-510/530
1/60: for PDW-510P/530P
Setting the shutter speed in ECS mode
Proceed as follows.
66
5-3 Setting the Electronic Shutter
1
2
When the RM-B150 Remote Control Unit is
connected
You can set the shutter speed of ECS with the rotary
encoder of the RM-B150.
Setting the shutter speed in SLS mode
Proceed as follows.
ECS mode
1
1 2
Setting the shutter speed in ECS (Extended Clear Scan) mode
Set the shutter speed mode to ECS.
For the operation, see the previous item "Setting the
shutter mode and standard-mode shutter speed".
EC S: 60. 00H z
Example of view finder screen display for ECS setting operation
Turn the MENU knob clockwise or counterclockwise
until the desired frequency appears.
The frequency range can be changed between 60.0 and
6000 Hz (PDW-510/530) or between 50.0 and 6000
Hz (PDW-510P/530P).
1 2
Setting the shutter speed in SLS (Slow Speed Shutter) mode
Set the shutter speed mode to SLS.