Monitor Volume Control - Sony PDW-530 Operation Manual

CH-1/2 CH-3/4 MONITOR
switch switch
position position
CH-1/2 CH-1
MIX
CH-2
CH-3/4 CH-3
MIX
CH-4
f MONITOR volume control
This control adjusts the speaker or earphone volume for
sounds other than the alarm sound. At the minimum
position, no sound can be heard.
g ALARM volume control
This control adjusts the speaker or earphone alarm volume.
At the minimum position, no sound can be heard.
However, if in the AUDIO-1 page of the
MAINTENANCE menu the MIN ALARM VOL item is
set to"SET", the alarm tone is audible even when this
volume control is at the minimum position.
THUMBNAIL
ESSENCE MARK
SUB CLIP
CLIP MENU
PRESET
REGEN
CLOCK
26
2-3 Audio Functions
Audio output
Audio channel 1
Mix sound of channels 1 and 2
Audio channel 2
Audio channel 3
Mix sound of channels 3 and 4
Audio channel 4
SEL/SET
S.SEL
SHIFT
F-RUN
SET
R-RUN
h Built-in speaker
During recording, the speaker can be used for monitoring
1)
the E-E sound, and during playback for monitoring
playback sound. The speaker also sounds alarms to
reinforce visual warnings.
The output level of the speaker can be lowered by
changing the setting of the SP ATT LEVEL item on the
AUDIO-1 page of the MAINTENANCE menu.
If you connect an earphone to the EARPHONE jack, the
speaker is automatically muted.
See 9-3 "Operation Warnings" on page 134 for
information about alarms.
1) E-E: Abbreviation of "Electric-to-Electric." In E-E mode, video and audio
signals input to the camcorder are output after passing through internal
electric circuits only. This can be used to check input signals.
9 LEVEL (CH-1/CH-2) controls
0 AUDIO SELECT CH-1/CH-2 switches
qa AUDIO IN CH-1/CH-2 / CH-3/CH-4 switches
qs LINE / AES/EBU / MIC selectors
qd +48 V/OFFf switches
qf AUDIO OUT connector
qg AUDIO IN CH1/CH2 connectors
qh DC OUT 12V connector
Audio functions (2)
Minimum Maximum
ALARM volume control