Show Interface Switchport - Cisco Nexus 5000 Series Command Reference Manual

show interface switchport

show interface switchport
To display information about all the switch port interfaces, use the show interface switchport command.
show interface switchport
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
EXEC mode
Command History
Release
4.0(0)N1(1a)
5.0(3)N1(1)
Usage Guidelines
You can configure the rate limit on the following Cisco Nexus 5000 Series switches using the switchport
monitor rate-limit 1G command:
• Cisco Nexus 5010 Series
• Cisco Nexus 5020 Series
This command does not require a license.
Examples This example shows how to display information for all Ethernet and virtual Ethernet interfaces:
switch# show interface switchport
Name: Ethernet1/1
Switchport: Enabled
Switchport Monitor: Not enabled
Operational Mode: fex-fabric
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Trunking VLANs Enabled: 1-3967,4048-4093
Administrative private-vlan primary host-association: none
Administrative private-vlan secondary host-association: none
Administrative private-vlan primary mapping: none
Administrative private-vlan secondary mapping: none
Administrative private-vlan trunk native VLAN: none
Administrative private-vlan trunk encapsulation: dot1q
Administrative private-vlan trunk normal VLANs: none
Administrative private-vlan trunk private VLANs:
Operational private-vlan: none
Unknown unicast blocked: disabled
Unknown multicast blocked: disabled
Cisco Nexus 5000 Series Interfaces Command Reference
132
Modification
This command was introduced.
Support to configure traffic rate limit on a switch port was added.
Show Commands