Lacp Graceful-Convergence - Cisco Nexus 5000 Series Command Reference Manual

lacp graceful-convergence

lacp graceful-convergence
To configure port channel Link Aggregation Control Protocol (LACP) graceful convergence, use the lacp
graceful-convergence command. To disable graceful convergence on a port channel interface, use the no
form of this command.
lacp graceful-convergence
no lacp graceful-convergence
Syntax Description
This command has no arguments or keywords.
Command Default
Enabled
Command Modes
Interface configuration mode
Command History
Release
5.1(3)N1(1)
Usage Guidelines
You can use this command only on a port channel interface that is in an administratively down state. You
cannot configure (or disable) LACP graceful convergence on a port chanel that is in an administratively up
state. If you do so, you will see the following error message:
ERROR: Cannot set/reset lacp graceful-convergence for port-channel10 that is admin up
To avoid port suspension, we recommend that you disable graceful convergence on LACP ports on a peer
Note
switch that is not running Cisco NX-OS.
This command does not require a license.
Examples This example shows how to enable LACP graceful convergence on a port channel:
switch# configure terminal
switch(config)# interface port-channel 100
switch(config-if)# shutdown
switch(config-if)# lacp graceful-convergence
switch(config-if)#
This example shows how to disable LACP graceful convergence on a port channel:
switch# configure terminal
switch(config)# interface port-channel 100
switch(config-if)# no lacp graceful-convergence
switch(config-if)#
Cisco Nexus 5000 Series Interfaces Command Reference
58
Modification
This command was introduced.
L Commands