Cisco Nexus 5000 Series Interfaces Command Reference - Cisco Nexus 5000 Series Command Reference Manual

Show Commands
Table 2: show interface loopback Field Description
Field
Loopback is ...
Hardware
MTU
BW
DLY
reliability
txload
rxload
Encapsulation
LOOPBACK
packets input
bytes
multicast frames
compressed
Description
Indicates whether the interface hardware is currently
active (whether carrier detect is present), is currently
inactive (down), or has been taken down by an
administrator (administratively down).
Hardware is Loopback.
Maximum transmission unit (MTU) of the interface.
Bandwidth (BW) of the interface in kilobits per
second.
Delay (DLY) of the interface in microseconds.
Reliability of the interface as a fraction of 255
(255/255 is 100 percent reliability), calculated as an
exponential average over 5 minutes.
Load on the interface for transmitting packets as a
fraction of 255 (255/255 is completely saturated),
calculated as an exponential average over 5 minutes.
Load on the interface for receiving packets as a
fraction of 255 (255/255 is completely saturated),
calculated as an exponential average over 5 minutes.
Encapsulation method assigned to interface.
Indicates whether loopback is set.
Total number of error-free packets received by the
system.
Total number of bytes, including data and MAC
encapsulation, in the error-free packets received by
the system.
Total number of multicast frames enabled on the
interface.
Total number of multicast frames compressed on the
interface.

Cisco Nexus 5000 Series Interfaces Command Reference

show interface loopback
121