Makita 9560CV Instruction Manual page 7

Electronic function
Constant speed control
• Possible to get fine finish, because the rotating
speed is kept constant even under the loaded
condition.
• Additionally, when the load on the tool exceeds
admissible levels, power to the motor is reduced
to protect the motor from overheating. When the
load returns to admissible levels, the tool will
operate as normal.
Soft start feature
• Soft start because of suppressed starting shock.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing side grip (handle)
CAUTION:
• Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
CAUTION:
• When using a depressed center grinding wheel/
Multi-disc, flex wheel, wire wheel brush or cut-
off wheel, the wheel guard must be fitted on the
tool so that the closed side of the guard always
points toward the operator.
► 1. Wheel guard 2. Bearing box 3. Screw 4. Lever
Loosen the lever on the wheel guard. Mount the wheel
guard with the protrusion on the wheel guard band
aligned with the notch on the bearing box. Then rotate
the wheel guard around 180 degrees. Tighten the lever
to fasten the wheel guard. If the lever is too tight or too
loosen to fasten the wheel guard, loosen or tighten the
screw to adjust the tightening of the wheel guard band.
1
► 1. Screw
To remove wheel guard, follow the installation proce-
dure in reverse.
7 ENGLISH
1
2
3
4