Note
5
.
3
W
A
N
2
5
.
3
W
A
N
2
The WAN2 interface of the Vigor 2620 router can connect to a cable modem, an ISP
supplied router or another network with an Internet connection.
The Ethernet WAN port is shared with the P2 port and must be configured to operate
in WAN mode as shown in section 5.3.1 Enabling the Ethernet WAN Port
If you are using a modem and your ISP has supplied you with a Username and
Password to connect to the Internet, go to section 5.3.2 PPPoE
If the router is connected to a modem and the ISP does not supply or require a
Username and Password to connect to the Internet, or you are connecting the WAN2
connection to another router or network go to section 5.3.3 Static or Dynamic IP
If the WAN 1 IP address displayed begins with 172.16.x.x, it's
possible that the ISP has not accepted the supplied Username
and Password for the Internet connection.
Check that the ISP Access Setup - Username and Password match
the details supplied by your ISP.
–
E
t
h
e
r
n
e
t
C
–
E
t
h
e
r
n
e
t
C
o
n
n
e
c
t
i
o
n
S
e
o
n
n
e
c
t
i
o
n
S
e
21
t
u
p
t
u
p