Lte Wan Configuration - Draytek Vigor2620 Series Quick Start Manual

5 . 4 L T E W A N C o n f i g u r a t i o n
5 . 4 L T E W A N C o n f i g u r a t i o n
The LTE WAN interface of the Vigor 2620Ln router can connect directly to a mobile
broadband network and operate as either a main internet connection or a backup
internet connection. The modem is integrated into the router instead of using a
separate USB modem and requires a SIM card to connect to the mobile broadband
network required.
The settings for the mobile broadband network will vary by provider, some will
require the APN (Access Point Name) while others may require that and a username
and password. If those details are not set, the mobile network may reject the
connection attempts of the Vigor LTE router, which will result in the router showing
no signal / no IP address.
To configure the LTE WAN interface on the router, it is first of all necessary to fit the
SIM card in the router, refer to section 4.1 for details of SIM card and antenna
installation.
After the SIM card has been installed, power on the router, access the router's web
interface and go to [WAN] > [General Setup] to confirm the LTE WAN options, by
clicking the LTE link:
In the LTE General Setup options, ensure that the connection is Enabled and set the
Active Mode as required:
27